Just add power tiler manual

[3G Ultra] Device Commands

Jun 24, 2024

Overview

The 3G System includes all 2GΩ/3G and 3G devices. Essentially, any device in a black metal casing. Commands on Just Add Power alter the live behavior of the device. Commands will execute immediately, but may not persist through reboot. Requires devices to be on justOS firmware version B1.0.0 or later. For Settings that alter the boot-up behavior of a device, see the 3G Device Settings article.

Access

• Telnet to the IP of the unit, at port 23
• RS232
  • White, 3-pin molex connector on the bottom of the unit. Make or request a Debug Cable to access.
  • 115200-8n1 baud rate

  All Commands are case-sensitive .

  Commands

  USB

  Name	Command	Variable(s)	Description	Applicable Units	Example
  USB Activate	usb start	N/A	Initiate USB connection with connected Transmitter.	All RX	usb start

  Video

  Name	Command	Variable(s)	Description	Applicable Units	Example
  Receiver Video Control	video $STATE	mute	Output black video and no audio	All RX	video mute
  		off	Disable HDMI output TV reports as if no HDMI is connected		video off
  		on	Enable HDMI output Opposite of off		video off
  		pause	Freezes the last frame on screen		video pause
  		play	Resume the video Opposite of pause and mute		video play
  		stop	Stop network services, go to debug screen		video stop
  		start	Enable network services Opposite of stop		video start
  Transmitter Video Control	video $STATE	off	Disable HDMI input Act as if no source is connected	All TX	video off
  		on	Enable HDMI input Opposite of off		video on
  		stop	Disable multicast network stream		video stop
  		start	Enable multicast network stream Opposite of stop		video start